CCNA 1 Chapter 9 v5.0 Exam Answers 12/2014 100%

1. How many bits are in an IPv4 address? 32

2. Which IPv6 address is most compressed for the full FE80:0:0:0:2AA:FF:FE9A:4CA3 address?FE80::2AA:FF:FE9A:4CA3

3. When a Cisco router is being moved from an IPv4 network to a complete IPv6 environment, which series of commands would correctly enable IPv6 forwarding and interface addressing?
Router# configure terminal
Router(config)# interface fastethernet 0/0
Router(config-if)# ipv6 address 2001:db8:bced:1::9/64
Router(config-if)# no shutdown
Router(config-if)# exit
Router(config)# ipv6 unicast-routing

4. What is the decimal equivalent of the hex number 0x3F? 63

5. Which two parts are components of an IPv4 address? (Choose two.)
host portion.
network portion.

6. Which network migration technique encapsulates IPv6 packets inside IPv4 packets to carry them over IPv4 network infrastructures? tunneling

7. A DHCP server is used to assign IP addresses dynamically to the hosts on a network. The address pool is configured with 192.168.10.0/24. There are 3 printers on this network that need to use reserved static IP addresses from the pool. How many IP addresses in the pool are left to be assigned to other hosts? 251

8. When will a router drop a traceroute packet? when the value in the TTL field reaches zero

9. What are three parts of an IPv6 global unicast address? (Choose three.)
an interface ID that is used to identify the local host on the network
a subnet ID that is used to identify networks inside of the local enterprise site
a global routing prefix that is used to identify the network portion of the address that has been provided by an ISP

10. A message is sent to all hosts on a remote network. Which type of message is it? directed broadcast

11. What two statements describe characteristics of Layer 3 broadcasts? (Choose two.)
Routers create broadcast domains
A limited broadcast packet has a destination IP address of 255.255.255.255.

12. When an IPv6 enabled host needs to discover the MAC address of an intended IPv6 destination, which destination address is used by the source host in the NS message? solicited-node multicast address

13. What is the prefix length notation for the subnet mask 255.255.255.224? /27

14. Which two things can be determined by using the ping command? (Choose two.)
the average time it takes a packet to reach the destination and for the response to return to the source.
whether or not the destination device is reachable through the network.

15. What is indicated by a successful ping to the ::1 IPv6 address? IP is properly installed on the host

16. Which two statements are correct about IPv4 and IPv6 addresses? (Choose two.)
IPv6 addresses are represented by hexadecimal numbers
IPv4 addresses are 32 bits in length.

17. Which two ICMP messages are used by both IPv4 and IPv6 protocols? (Choose two.)​
protocol unreachable
route redirection

18. What are two types of IPv6 unicast addresses? (Choose two.)
link-local
loopback

19. The decimal equivalent of the binary number 10010101 is 149

20. Open the PT Activity. Perform the tasks in the activity instructions and then answer the question.
Which message is displayed on the web server? Correct configuration!

20. An IPv6 enabled device sends a data packet with the destination address of FF02::1. What is the target of this packet? all IPv6 enabled nodes on the local link

21. 

22.